3.3
Flash Image to Board
Use the following steps to flash the OS to the BOXER-8621AI.
1)
Open terminal on the Ubuntu Host PC, then access the folder you extracted in
the previous section.
2)
Enter the following command in terminal to flash the image:
$ ./flashboxer.sh -s 62517420 nvme
3)
Wait until the image is installed. Once finished you should see the following:
From the second time onwards, you can flash 10 images once at most, using the flash
command as follows:
$ ./flashboxer.sh -m nvme
Chapter 3 – BSP Flash Guide
34