Advertisement
7
KP-800, KP-1600, and KP-2000
•
Rack in the CiC into the gear cradle by placing
both 1-1/4 inch wrenches (l)(fig. 8) on to the cam
lever protrusions (m)(fig. 9). Simultaneously pull
them down to and use the extra cam lever
protrusions to continue rotating them until the cam
levers reach their stop position (n)(fig 9).
Note: Extra force will be required as the finger
clusters of the CiC engage the gear power
contacts, however it should rack in smoothly to
the cam stop.
•
If the CiC stops before being fully racked in, pull it
back out and investigate what is blocking it and
clear it so that racking in can be completed.
Fig. 8
l
Fig. 9
m
n
Advertisement
