Table of Contents
Advertisement
Available languages
Available languages
3.
Remove the burner from the grill by lifting the burner out.
4.
Use a 6 mm socket and wrench or a 6 mm nut driver to
remove the LP brass orifice from the end of gas valve. The
main burner NG orifice is located behind the LP orifice, so
no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly
removed inside of the burner opening.
5.
Reinsert the burner and reattach using the cotter clip and
screws previously removed. Repeat the procedure for
each main burner.
6.
Position the igniters so they are 3.2 mm / 1/8 in away from
each burner.
Change The Sear Burner Orifice
1.
Disconnect the quick connector.
2.
Remove the two thumb screws.
3.
Use a screwdriver to remove screw from the igniter pin
and two screws on the rear of the searing burner.
A
4.
Lift the burner starting from the back, as shown.
26
Advertisement
Table of Contents
