Table of Contents
Advertisement
Install the connecting screw
3
tube , and place the square shaft
and compressed spring into the
hole of the lever. (The square
shaft compressed spring must
be put towards the lever)
Attention
Please cut the key tailpiece according to your needs
and use square shaft and connecting screw tube
with proper length to fix the screw tube.
Tighten up the mounting plate
5
with 3 anchor screws against the
inside of the door.
Pass the connection wire
4
through the hole on the mortise.
Align the cylinder key tailpiece
and the square shaft with the 2
rotary holes on the mortise, and
insert them to make sure the
outside escutcheon is kept close
to the outside of the door.
Put the compressed spring,
6
then the square shaft into the
inside escutcheon. Insert the
outside escutcheon connection
wire and mortise wire into the
corresponding sockets on the
inside escutcheon. Align the
square shaft to the rotary holes
on the mortise and insert them to
make the inside escutcheon close
to the inside of the door.
Attention
Please
make
sure
connection wire is hidden in the
door hole.
the
extra
7
Advertisement
Table of Contents
