Vacuum Sealing; Vacuuming The Tube Film - Silvercrest SV 120 A1 Operating Instructions Manual

Vacuum sealing

Vacuuming the tube film

You can also suck the air out of the bag (vacuum) during welding:
NOTE
► Do not evacuate bags that contain only liquids . These could be sucked up
during the vacuum sealing process .
If small quantities of liquid or food do get sucked up, they will be deposited
in the small drip tray that is located between the lower sealing ring 5 .
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5 . The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7 . Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1 . Ensure that both corners of the appliance lid 1
click closed . If necessary, press them down once again on the markings
and
NOTE
► Ensure that the upper 0 and the lower sealing rings 5 are not damaged!
Otherwise the device cannot suck the air out of the bag .
► If either one of the sealing rings 0/5 is damaged, simply pull it out of the
groove and press the replacement sealing ring into the groove .
■ 64 │ GB │ MT
so that the appliance lid 1 clicks into place and locks shut .
SV 120 A1