Product Overview; Controls - Toro Z Master 74927 Operator's Manual

Product Overview

1. Height-of-cut deck lift
pedal
2. Transport lock
3. Parking brake lever

4. Controls

5. Motion control levers
Controls
Become familiar with all the controls before you start the
engine and operate the machine (Figure 4 and Figure 5).
2
1
6
1. PTO Switch
2. Choke
3. Throttle control
g019753
Figure 4
6. Roll bar
7. Seat belt
8. Fuel cap
9. Mower deck
10. Caster wheel
3
4
Figure 5
4. Hour meter/Safety
interlock display/Fuel
gauge
5. Ignition switch
6. Fuses
Hour Meter
The hour meter records the number of hours the engine has
operated. It operates when the engine is running. Use these
times for scheduling regular maintenance (Figure 6).
Fuel Gauge
The fuel gauge is located with the hour meter and the bars
light up when the ignition switch is on (Figure 6).
The indicator light appears when the fuel level is low
(approximately one gallon remaining in the fuel tank).
Safety Interlock Indicators
There are symbols on the hour meter and the indicate with a
black triangle that the interlock component is in the correct
position (Figure 6).
Battery Indicator Light
If the ignition key is turned to the On position for a few
seconds, the battery voltage will be displayed in the area
where the hours are normally displayed.
The battery light turns on when the ignition is turned on
and when the charge is below the correct operating level
(Figure 6).
5
1. Fuel gauge (bars)
2. Battery light
G008951
3. Hour meter
Throttle Control
The throttle control is variable between Fast and Slow.
Choke
Use the choke to start a cold engine. Pull the choke knob up
to engage it.
12
Figure 6
4. Safety interlock symbols
5. Low fuel indicator light