Table of Contents
Advertisement
Low-cut
93-4264
(Optional)
High-cut
94-6392
(Optional)
Fairway
137–6097
(Optional)
Fairway
137-6092
EdgeMax
(optional)
Note:
For heights of cut greater than 9.5 mm (0.375
inch), install the high-height-of-cut kit.
Adjusting the Height-of-Cut Gauge
Before adjusting the height of cut, set the height-of-cut
gauge as follows:
1.
Loosen the nut on the gauge bar and set the
adjusting bolt to the desired height of cut
13).
Note:
The distance between the bottom of the
bolt head and the face of bar is the height of cut.
Figure 13
1. Gauge bar
2. Height-adjusting bolt
2.
Tighten the nut.
Adjusting the Height of Cut
1.
Loosen the locknuts securing the height-of-cut
arms to the cutting-unit side plates
4.7 to 25.4 mm (0.188 to
1.00 inch)
7.9 to 25.4 mm (0.312 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
(Figure
g000489
3. Nut
(Figure
14).
1. Height-of-cut arm
2. Locknut
2.
Hook the bolt head of the height-of-cut gauge
onto the right side of the cutting edge of the
bedknife and rest the rear end of the bar onto
the rear of the roller
1. Gauge bar
3.
Rotate the adjusting bolt until the roller contacts
the front of the gauge bar.
4.
Repeat steps
5.
Adjust both ends of the roller until the entire
roller is parallel to the bedknife.
Important:
When set properly, the rear
and front rollers contact the gauge bar and
the bolt is snug against the bedknife. This
ensures that the height of cut is identical at
both ends of the bedknife.
6.
Tighten the nuts to secure the adjustment
enough to remove play from the washer.
11
Figure 14
3. Adjusting bolt
(Figure
15).
Figure 15
2
and
3
for the left side.
g278482
g004003
Advertisement
Table of Contents
