Installing The Hoop Link, Offset Link, Or Chain Link - Toro 04654 Operator's Manual

Installing the Hoop Link,
Offset Link, or Chain Link
For cutting units mounting on a traction unit with a
serial number prior to 240000001, obtain and install
the proper lift link as follows:
Note:
The 2 bolts used to mount the lift link are
shipped installed on the cutting unit.
•
For Greensmaster 3120 and 3150 traction units,
install the hoop link supplied with the traction unit.
Install the hoop link (Part No. 105-5740) to the top
of the cutting unit with 2 bolts. Torque the bolts to
34 to 40 N∙m (25 to 30 ft-lb)
1. Hoop link (Part No. 105-5740)
•
For the Greensmaster 3250-D traction units, install
the offset link (Part No. 110-2397) supplied with
the traction unit.
Install the offset link
cutting unit with 2 bolts. Torque the bolts to 34 to
40 N∙m (25 to 30 ft-lb).
Important:
Position the lift hook offset toward
the front of the cutting unit.
(Figure 5).
Figure 5
(Figure 6) to the top of the
1. Offset link (Part No. 110-2397)
g020064
6
Figure 6
g020065