Installing The Spring Rake - Toro 08752 Operator's Manual

Installing the Spring Rake

Installing the Spring Rake on a
Tooth Rake
1. Install the curved pivot bracket to the spring rake
as shown in Figure
1. Shoulder bolt
2. Washer (17/32 x 1-1/16
inch)
3. Curved pivot bracket
2. Connect the pivot bracket to the tooth rake as
show in Figure 4.
1. Spring rake
2. Tooth rake bracket
3. Curved pivot bracket
3.
Figure 3
4. Washer (15/32 x 59/64
inch)
5. Nut (7/16 inch)
6. Spring rake
Figure 4
4. Clevis pin
5. Cotter pin
6. Washer (17/32 x 1-1/16
inch)
3. Secure the transport chains to the lift arm using
one of the following procedures:
A. Mount 2 hooks to the back of the lift arm
with 2 nuts (3/8 inch)
chains to the hooks at the desired length.
g003428
1. Nut (3/8 inch)
B. Secure each chain to the side of the lift arm
with a bolt (3/8 x 2-1/2 inch), 2 washers (3/8
x 7/8 inch), a spacer, and a nut (3/8 inch)
as shown in
g003429
5
(Figure 5). Secure the
Figure 5
2. Hook
Figure 6.
g005146