Table of Contents
Advertisement
CAUTION
Fingers can be pinched between the
attachment and traction unit adapters.
Lift and move the attachment using the
handle on the back of the attachment
adapter.
7.
Pivot the locking lever to the right to lock the
adapters together.
8.
Secure the third link of each chain to the outside
of the lift arm
(Figure
inches), 2 washers (3/8 x 7/8 inch), a spacer,
and a nut (3/8 inch).
Note:
If the chains are secured to the hooks,
reconnect at the desired length.
Note:
The chains must be slack when the rake
is in the lowered (operating) position.
Figure 10
1. Bolt (3/8 x 2-1/2 inches)
2. Washer (3/8 x 7/8 inch)
3. Spacer
9.
With the rake mounted and secured on the
traction unit, measure the gap between the top
washer and the spacer in the link assembly on
the attachment adapter as shown in
10) using a bolt (3/8 x 2-1/2
4. Third link of the chain
5. Nut (3/8 inch)
Figure
11.
1. Jam nut
2. Adjustment nut
3. 1.5 to 2 mm (0.060 to
0.080 inch)
10.
If the gap is not correct, loosen the jam nut and
tighten or loosen the adjustment nut on the link
assembly as needed to change the gap.
g003431
7
Figure 11
4. Lift-yoke shoulder
5. Heavy washer
g220790
Advertisement
Table of Contents
