Toro 08752 Operator's Manual page 6

1. Bolt (3/8 x 2-1/2 inches)
2. Washer (3/8 x 7/8 inch)
3. Spacer
Note:
You can use the fasteners from the
tooth rake for this step.
Installing the Spring Rake on the
Traction Unit
1. Install the ball hitch assembly to the spring rake
as shown in Figure
1. Shoulder bolt
2. Washer (17/32 x 1-1/16
inch)
3. Ball hitch assembly
2. Connect the ball hitch assembly to the adapter
as shown in Figure 8
Figure 6
4. Tooth rake transport chain
5. Spring rake transport
chain
6. Nut (3/8 inch)
7.
Figure 7
4. Washer (15/32 x 59/64
inch)
5. Nut (7/16 inch)
and Figure 9.
1. Clevis pin
2. Washer (17/32 x 1-1/16
g003430
inch)
3. Bracket stop plate
1. Bolt (1/2 x 5-1/2 inches)
2. Clevis pin
3. Washer (17/32 x 1-1/16
inch)
3. Remove any attachment from the rear of the
traction unit.
g269319
4. Back the traction unit into position in from of the
attachment adapter and lower the traction unit
adapter.
5. Ensure that the locking lever is pivoted to the
left (unlocked position) as viewed from the rear
of the machine.
6. Slide the attachment adapter onto the traction
unit adapter.
6
Figure 8
4. Attachment adapter
5. Latch mechanism
6. Cotter pin
Figure 9
4. Spacers
5. Cotter pin
6. Nut (1/2 inch)
g265963
g265961