Philips 9000 Series Manual page 23

Tip: For optimal performance, lubricate the teeth of the attachment
with a drop of sewing machine oil regularly.
Cleaning the beard styler attachment
Clean the beard styler attachment every time you have used it.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the centre to pull it off the beard styler
attachment. Do not pull at the sides of the comb (Fig. 31).
2 Switch on the appliance.
3 Rinse the beard styler attachment and the comb separately under
a warm tap (Fig. 56).
4 After cleaning, switch off the appliance.
5 Carefully shake off excess water and let the beard styler
attachment and comb dry.
6 For optimal performance, lubricate the teeth of the attachment
with a drop of sewing machine oil regularly.
Cleaning the cleansing brush attachment
Clean the cleansing brush attachment every time you have used it.
1 Switch off the appliance.
2 Detach the brush head from the brush base (Fig. 57).
3 Clean the parts thoroughly with warm water and soap.
4 Dry the cleansing brush attachment with a towel.
Storage
1 Store the appliance in the pouch supplied (Fig. 58).
Note: Make sure the appliance is dry before you store it in the
pouch.
2 Put the protection cap on the cleansing brush attachment to
protect it from dirt accumulation (Fig. 59).
Replacement
Replacing the shaving heads
For maximum shaving performance, we advise you to replace the
shaving heads every two years (Fig. 60). Replace damaged shaving
19
English