SAFETYINSTRUCTIONS 安全指 引 請 務必遵 守 Disconnect power supply before maintenance. 維護保養前先斷電。 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
安 裝 注意事項 INSTALLATION INSTRUCTIONS WARNING 警 告 Please select 60227 IEC 53 ordinary Please install a suitable all-pole polyvinyl chloride sheathed cord. switch which the contact separation Nominal cross-sectional area of is more than 3mm. Please install the conductors is 3x1.5 mm .
Page 4
安 裝 注意事項 INSTALLATION INSTRUCTIONS WARNING 警告 Do not operate the product other The product can not be located just than the rated voltage below a power outlet socket. (220 V 50 Hz). 禁止 把 本 產 品 安 放 在 電 源 插 座 下使 用。 禁...
安裝 要 求 INSTALLATION REQUIREMENTS Do not form the duct as shown below: 安裝管道應該避免以下情況: Wave pipe 管道 Adapter 出風口接頭 Do not install the product in places Do not install onto slanting ceiling. with high temperature. 請勿 安 裝在傾 斜 的天花 板 上。 請...
安裝 要 求 INSTALLATION REQUIREMENTS The product is not provided with power cord, all-pole switch and leakage protection switch. Please purchase them in market. 本 產品沒 有提供 電 源線, 電 源全極 開 關和漏 電 保護開 關 ,需用 戶 另購。 When you install plastic part, do not exert too much strength to fixing the screw, otherwise, the product would be damaged.
部 件 名 稱和尺寸 PART NAME AND DIMENSIONS Unit:mm 單位:mm No . Part name No . Part name 部件名稱 序號 序號 部件名稱 Cord cover 扇葉 接線蓋板 Shutter Filter assembly 高氣密性擋片 過濾網組合 Mode button panel Main body 模式按鈕面板 機體 Adapter Louver assembly 出風口接頭...
安 裝 前 事 項 WORK BEFORE INSTALLATION 安裝前準備 Preparation before installation Leakage protection switch (Need to be purchased) Install an all-pole switch with the contact separation not less 漏電保護開關(另購) than 3 mm and specifications not lower than 250 V 13 A Fixed wiring Main body and a leakage protection switch (with the leakage current...
Page 9
安裝方法 HOW TO INSTALL Remove the screws(2 pcs) on the cord cover, Loosenthescrewsofthecordclip. then open the cord cover. 鬆脫 固定線夾 的螺絲。 取下接 線 蓋 板 上 的 螺 絲 ( 2 ) 顆 ,打開接線蓋板。 Cord cover 接 線 蓋 板 Screws 螺絲...
Page 10
安裝方法 HOW TO INSTALL Connecting the duct pipe Refer to Section Clipping position 4.Duct Pipe Connection on P.14. Locating slot of the adapter of the main 參考第14頁 4.管道的連接 連接 管 道 。 出風口接頭卡位 body Push the main body upward into the ceiling board 機體固定槽...
Page 11
安裝方法 HOW TO INSTALL Unit:mm Fix the suspenders (M8 or M10, need to be purchased) 單位:mm on the ceiling according to dimensions on right. 根據右 圖 尺 寸 將 吊 桿(另購M8或M10)安裝於天花。 Ceiling 天花 Suspender 吊桿 Ceiling Suspender 天花 吊桿 安裝懸吊支架。 將懸吊支架固定於吊桿。...
Page 12
安裝方法 HOW TO INSTALL 出風口接頭定位槽 將機體緊靠出風口接頭往上推入天花板與木框,並使 機體上卡位卡入出風口接頭槽中(否則漏風),使用3顆 4x13自攻螺絲將機體牢固地固定。 CAUTION 注 意 懸吊支架螺絲孔 (3 pcs) 自攻螺絲 3顆 固 定機 體 的 螺 絲 ,必須 通過 懸 吊支 架螺 絲孔 將機體固定 於懸吊 支 架 和 天 花 板 ,否 則產 品有 掉 落的 危險 。 Use one 4 x 20 self-tapping screw to fix the adapter.
Page 13
安裝方法 HOW TO INSTALL Fix the adapter to the main body with the 4x10 self-tapping screw providedin the accessory Self-tapping package. screw 4 x10 自攻螺絲 用 顆 4x10 的自攻螺絲 ,將出風口接頭固定於 機體 。 4x10 Self-tapping screws 4 x13 Remove the installation suspension bracket 4x13 自攻螺絲...
Page 14
Suspend the duct pipe from the ceiling to products of the following models provided prevent external force exerted on the unit by Panasonic.) body. The duct pipe connected to outside of the room must be slanted to prevent rain 將管罩或管蓋安裝到牆外。...
Page 15
安裝方法 HOW TO INSTALL Open two 8 holes in the bathroom wall as shown below. And install the controller holder. 在浴 室 的 牆 壁 上 開2顆 8的安裝孔,將遙控器 膠塞( 8×20 mm)(另購) 底 座安 裝 於 牆 上 。 Install two R03(AAA) manganese batteries in the 自攻螺絲( 4×16 mm) remote control.
試 運 轉 TEST RUN After connecting the power, please check the following item using the remote control: Does the fan revolve normally? Does it have abnormal vibration or noise? Does it blow out hot air? Is each button on remote control perform its right function? 接通電源,按動遙控器上各個功能按鍵,檢查以下項目:...
FUNCTION OF REMOTE CONTROL 遙控器 功 能 介 紹 Notice 提示事項 When the heating mode or hot drying mode is switched to the air ventilation mode, the fan blade will run at a low speed for 20 seconds to cool the heater down, then enter the air ventilation mode.
定時功能的使用方法 HOW TO USE TIMER FUNCTION For running time adjusted 調 整 運轉時 間 時使用 During operation, you can press the button to change the running time. 運轉中可通過 調整運轉時間。 Each time you press the button, the time will increase accordingly. 每按一次...
風 向 功 能 的使用方法 HOW TO USE AIR DIRECTION FUNCTION For adjusting air direction 調整風 向 時使用 During running, you can press the button to adjust the air direction. 運轉中可通過 按鈕,調整風向。 The initial air direction setting of HEAT, DRY HOT and DRY COOL is AUTO mode.
HOW TO USE HEATING FUNCTION 暖氣功能的使 用 方 法 Use when you feel cold in a bath 在浴室 中 感到冷 時 使用 Before taking a bath, start the heating function to warm the bathroom beforehand. 在沐浴前開暖氣功能,可提前將浴室升溫。 Press the button to start the heating mode. 按...
HOW TO USE DRYING FUNCTION 乾 燥功能的使用 方 法 Use when you need to dry the bathroom or clothes 乾 燥 浴室或 乾 衣物時 使 用 Press the button to start the DRY HOT mode. It will switch to the DRY COOL mode if you press this button again. 按...
熱啟動功能時 滅 慢速閃爍 When the running indicator blinks quickly, Please disconnect the power supply, and contact Panasonic customer consultation service center or your distributor. 運轉 指 示 燈 快 速 閃 爍 時, 請斷 開電 源, 且與Panasonic客戶諮詢服務中心或經銷商聯繫。 Blinking fast: On for 0.5 seconds and off for 0.5 seconds 快速...
使用及維 護 注 意 事項 USE AND MAINTENANCE INSTRUCTIONS WARNING 警告 Once flammable gas leaks, do not Do not disassemble this product start any function of this product. for repair or reconstruction. 禁止 拆解 本 產 品 進行 修 理 或改 造。 當...
Page 24
使用及維 護 注 意 事項 USE AND MAINTENANCE INSTRUCTIONS WARNING 警告 Do not put the battery in reach of Please promptly take out of the children and infants. exhausted batteryfromthe remotecontrol. 禁 止將 電 池 放 置 在 嬰 幼 兒 可 觸 及 到 用...
Page 25
MAINTENANCE 維 護 方 法 Cleaning Precautions 清 潔注意 事 項 Cleaning the louver: 面板組合的清潔: 1. To prevent color change and accelerated aging of the panel, do not use any type of diluent, alkaline cleaner, benzene, alcohol, antiseptic, or steel ball as shown below. 為避免導致面板變色及加速面板老化,請勿使用類似於圖示的...
MAINTENANCE 維 護 方 法 Clear the filter cleaning indication at the receiving part of the main body. 取消機體接收部過濾網清潔提示。 Each time cleaning the filter , you are advised to reset the accumulated time of the filter cleaning indication. (Press and hold the MODE button for 3 seconds. A “beep” sound means the resetting is done.) 長按機體接收部模式按鈕3秒,聽到“嗶”的一聲,過濾網清潔提示將被解除。(過濾網...
常 見 故障的識別 與 處 理 Check the product according to the table below if a fault occurs. If an error still occurs, check that the all-pole switch connected to this product is disconnected, and contact Panasonic customer consultation service center or your distributor.
Page 28
本 產品 機體 通 過 防 水試 驗, 符合IPX2要求, 遙控器通過 防濺水試驗,符合IPX4要求。 Insulation class E E級絕緣 The above specification may be changed without further notice. 上 述參數如有 變動 ,恕不另行通知。 Web Site: http://www.panasonic.com Issue date 發行: 09/2017 Panasonic Corporation 2017 P0917-1097 30BG34200AH...