NEC MultiSync E658 Setup Manual page 7

Handling the power cord.
Handle the power cord with care. Damaging the cord could lead to fire
or electric shock.
• When connecting the power cord to the product's AC IN terminal,
make sure the connector is fully and firmly inserted.
• Fasten the power cord to the product by attaching the clamp to
prevent loose connection.
• Do not connect or disconnect the power cord with wet hands.
• When connecting or disconnecting the power cord, pull the power
1
cord out by holding onto its plug.
• When cleaning the product, for safety purposes, unplug the power
cord from the power outlet beforehand. Regularly dust off the power
cord by using a soft dry cloth.
• Before moving the product, make sure the product power is off,
then unplug the power cord from the power outlet and check that all
cables connecting the product to other devices are disconnected.
• When you are not planning to use the product for an extended
period of time, always unplug the power cord from the power outlet.
Do not bind the power cord and the USB cable. It may trap heat and
2
cause a fire.
Do not connect to a LAN with excessive voltage.
When using a LAN cable, do not connect to a peripheral device with
3
wiring that might have excessive voltage. Excessive voltage on the
LAN port may cause an electric shock.
Do not climb on the table where the product is installed. Do not install
the product on a wheeled table if the wheels on the table have not
4
been properly locked. The product may fall, causing damage to the
product or personal injury.
Installation, removal, and height adjustment of the optional wall mount.
• When installing the wall mount, handle the unit with care to avoid
5
pinching your fingers.
Do not push or climb on the product. Do not grab or hang onto the
product.
6
The product may fall, causing damage to the product or personal
injury.
Do not impact the LCD panel surface, it can cause serious damage to
7
the product or personal injury.
CAUTION
English-7
EN