Sealey AVR1500FP.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Read the instruction
Wear safety footwear
manual
1. SAFETY
GENERAL SAFETY.
WARNING! Ensure Health & Safety, local authority, and

general workshop practice regulations are adhered to
when using this equipment.
WARNING! TRAPPING DANGER – Keep hands and

fingers away from the sprockets and duplex chain.
Keep the work area clean, uncluttered and ensure there

is adequate lighting.
Maintain correct balance and footing. Ensure the floor is

not slippery and wear non-slip shoes.
Remove ill-fitting clothes. Remove ties, watches, rings,

other loose jewellery. Contain and/or tie back long hair.
Wear appropriate protective clothing.

Familiarise yourself with the applications, limitations and

potential hazards of the vehicle lift.
DO NOT use to achieve a task the vehicle lift was not

designed to perform.
DO NOT allow untrained persons to use the vehicle

hydraulic lift.
PRE OPERATIONAL SAFETY.
Ensure adequate level space around the vehicle for the

operator and the lift.
Apply grease, if not apparent, to the carriage rollers, main

upright guides, sprockets and duplex chain to assist the
smooth action of the lifting and lowering.
DO NOT operate the vehicle lift if parts are damaged or

missing as this may cause failure and/or personal injury.
Before commencing lift, make a visual inspection of the

vehicle lift to ensure there is no sign of fractured welds,
bent adaptors or loose fixings. If found, do not use the unit
and refer to your local Sealey dealer for advice and
replacement parts. Tighten loose fixings.
Before commencing lift ensure all vehicle tyres are

correctly inflated and the vehicle sills and bodywork is
structurely sound.
Before commencing lift ensure vehicle wheels are locked,

chocked or hand braked.
OPERATIONAL SAFETY.
DANGER! DO NOT put any limb beneath vehicle whilst

lifting or lowering. Always insert safety stop bar when
the vehicle is raised to working height. The stop bar
must take the load not the hydraulics.
After lifting to working height insert safety stop bar and

lower load to bear on the stop as per instructions in later
sections 6.8 and 6.9.
POST OPERATIONAL SAFETY.
When not in use, clean and store the vehicle lift in a safe,

dry, childproof location.
Maintain the vehicle lift in good condition.

Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will
invalidate the warranty.
© Jack Sealey Limited
INSTRUCTIONS FOR:
AIR/HYDRAULIC VEHICLE LIFT 1.5TONNE
WITH FOOT PEDAL
MODEL N : AVR1500FP.V2
O
Wear eye
Wear protective
protection
gloves
2. INTRODUCTION
2.1
Fitted with air/hydraulic motor for easy operation or can be
raised using foot pump and includes adaptors to lift via wheel
or body. This specifically designed piece of equipment is a
perfect addition to any busy workshop or repair centre want-
ing to raise a vehicle off the floor quickly and safely. Can be
used for lifting cars, 4x4s and vans. Vehicles can be lifted
from the side, front, back or wheels with supplied adaptor.
The unit offers significant assistance with bringing vehicles
into an ergonomic working position. Ideal for a wide variety of
applications including welding, grinding and painting.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . AVR1500FP.V2
Maximum Load: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1500kg
Maximum Lift Height: . . . . . . . . . . . . . . . . . . . . . . . . . . 995mm
Working Air Pressure . . . . . . . . . . . . . . . . . . . . 123psi (8.5bar)
Overall Height: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1315mm
Overall Width:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 705mm
Overall Length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 990mm
Locking Spacing: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80mm
Locking Positions: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .110kg
Fig.1
Hook on hook off
wheel cradle
adaptor shown
Original Language Version
Offers fast, easy lifting, with or without an air supply.
Fixed
Castors
Transit
Handles
Swivel
Castors
AVR1500FP.V2 Issue: 1 - 20/04/15