Motorola 507AFDMTB Manual page 26

Caution! Don't use sharp objects to remove frost from the
freezer compartment. Only after the interior is completely dry
should the appliance be switched back on and plugged back
into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can
cause seals to stick to the cabinet and tear when you open the
door. Wash seal with a mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should
the appliance be powered on.
Replacing the LED light:
Warning: The LED light must not be replaced by the user! If the
LED light is damaged, contact the brand helpdesk for
assistance. To replace the LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other
hand while pressing the connector
4. Replace LED light and snap it correctly in place.
Defrosting
Water contained in the food or getting into air inside the
fridge by opening doors may form a layer of frost inside. It will
weaken the refrigeration when the frost is thick.
This appliance is a frost-free refrigerator, Automatic defrosts
itself regularly, without manual defrost. Water from defrosting
will be drained into a drip tray through a drain pipe. Then the
water within the drip tray will be evaporated.
latch.