Advertisement
INTRODUCTION
INTRODUCTION
INTENDED USE
This Komatsu FORESTRY MACHINE is designed to be used mainly for the following work:
● Log loading
● Log stacking
● Stump handling
DIRECTIONS OF MACHINE
In this manual, the terms front, rear, left, and right refer to the travel direction as seen from the operator's cab when the
operator's cab is facing the front and the sprocket is at the rear of the machine.
BREAKING IN THE MACHINE
Your machine has been thoroughly adjusted and tested before shipment. However, operating the machine under severe
conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to break in the machine
for the initial 100 hours, as indicated by the service meter.
During break in:
●
Idle the engine for 5 minutes after starting it up.
●
Avoid operation with heavy loads or at high speeds.
●
Avoid sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency.
The precautions given in this manual for operating, maintenance, and safety procedures are only those that apply when this
product is used for the specified purpose. If the machine is used for a purpose that is not listed in this manual, Komatsu cannot
bear any responsibility for safety. All consideration of safety in such operations is the responsibility of the user.
Operations that are prohibited in this manual must never be carried out under any circumstances.
See "ROAD BUILDER RECOMMENDED APPLICATIONS" on page 2-113
0-4
● Log unloading
● Log handling
Find manuals at https://best-manuals.com
PC200/220LL-7L
Advertisement
