Optional Operations - Sony MVS-8000 User Manual

Hide thumbs Also See for MVS-8000:

Table of Contents

Optional Operations

Making cross-point settings

Cross-point assign tables can be set not only for main output but also for sub

You can set cross-point assign tables for the following banks.

The table actually used is that for which the control panel delegation button is

For details, see "Cross-Point Settings (Xpt Assign Menu)" in Chapter 19

Enabling DME wipe operations for sub

By factory default, DME wipe operations are inhibited for sub background. To

enable them, in the Engineering Setup >Switcher >Config menu, set [DME

Wipe Sub Enable] to On.

Multi Program 2

With the normal operations, create the main video.

Press the [SUB] button, turning it on, and turning off the [MAIN] button.

Now you can create the sub video.

Create the sub video.

The basic method of operation is the same as for the main video, except

that the utility 2 bus signal is assigned to background A, and the utility 3

bus signal is assigned to background B.

For sub, only keys 2 to 4 can be used, and for wipes, standard wipe patterns

only. There are also other differences in operation from standard mode.

For details, see "Differences Between Multi Program 2 Mode and

Standard Mode" (page 501) and "Restrictions on Using Multi Program 2

Mode" (page 502).

Press the [MAIN] and [SUB] buttons simultaneously, turning them on.

If both buttons are lit, the control panel shows the status of main.

Carry out the transition.

Both main and sub video images are switched.

M/E-1 SUB to M/E-3 SUB