Frame Recording Mode - Canon C200B Instruction Manual

Special Recording Modes
• About the time code during pre-recording mode:
- The time code of the clip will start a few seconds before the REC button was pressed.
- The time code will be recorded with the running mode set to [Free Run].
- If the time code mode was set to [Regen.], or to [Preset] with [Rec Run] running mode, the time code
116
running mode will be changed automatically to [Free Run] when pre-recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.

Frame Recording Mode

We recommend operating the camera remotely or stabilizing the camera, for example, on a tripod. Sound is not
recorded in this mode.
Operating modes:
Activating and Configuring
1 Open the [Recording Mode] submenu.
> [Æ ! Recording/Media Setup] > [Recording Mode]
2 Select [Frame Recording] and then press the joystick.
• [FRM STBY] appears at the top of the screen (with [FRM] flashing).
Recording
1 Press the REC button to begin recording.
• The camera automatically records one frame.
• The tally lamp illuminates.
• [FRM STBY] changes to [Ü FRM REC] while recording frames and [Ü FRM STBY] when frames are not
being recorded.
• Repeat until you finish recording.
2 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
• Frame recording mode ends and all of the recorded frames are joined together into one clip.
• The tally lamp goes out and [STBY] appears at the top of the screen.
NOTES NOTES
• You can use only one special recording mode at a time.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• If you change the main recording format or system frequency, frame recording mode will be canceled.
• About the time code during frame recording mode:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when interval recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the SDI terminal or HDMI OUT terminal.