Clearances And Dimensions - Sharp SMD2489ES Installation Manual

CLEARANCES AND DIMENSIONS

• Dimensions that are shown in Figure 1 must be used. Given
dimensions provide minimum clearance. Locate electrical outlet
in the shaded area in the upper left-hand corner of the cutout. See
Figure 9.
• Contact surface must be solid and level. Pay special attention to
the floor on which the Microwave Drawer will sit. The floor of
the opening should be constructed of plywood strong enough to
support the weight of the oven (about 100 pounds).
• Check location where the Microwave Drawer will be installed
for proper electrical supply.
• Your oven can be built into a cabinet or wall as a stand-alone
unit. It can also be installed under gas or electric wall ovens, the
24" MICROWAVE DRAWER STANDARD MOUNT AND MEASUREMENTS
B
M
G
I
J
L
O
Figure 1
A. 6" (152.40 mm)
B. Suggested electrical
outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 3 / " (88.90 mm)
1
2
F. 4" (101.60 mm)
/ " (561.98 mm)
G. 22 1
8
opening
H. 14 / " (376.24 mm) to
13
16
bottom of Anti-Tip block
I. Allow / " (22.22 mm)
7
8
overlap
A
D
F
K
P
I
J. 23 / " (596.90 mm)
1
2
minimum depth
K. Allow / " (11.11 mm)
7
16
overlap
L. 36" (914.40 mm)
countertop height
M. Allow / " (11.11 mm)
7
16
minimum space
N. Floor must support
100 lb (45.4 kg)
O. 24" (609.60 mm)
cabinet minimum
P. 15 / " (395.29 mm)
9
16
opening
SuperSteam oven models SSC2489DS & SSC2489GS or under
the cooktop models SDH3042DB, SDH3652DB, SCH2443GB,
SCH3043GB, SCR3041FB, SCR3042GB, SCR2442FB,
SCR3041GB, and SCR3042FB.
• Be sure that the clearance of the floor between the wall oven and
the microwave drawer is a minimum of 2-inches.
• The microwave interior will easily accommodate a 9" x 13" oblong
dish or a bag of microwave popcorn.
• The oven can also be mounted flush. Please see instructions for
flush mounting.
C
E
F
H
E
N
Figure 2
A. 21 / " (549.28 mm)
5
8
B. 4 / " (119.06 mm)
11
16
C. 1 / " (44.45 mm)
3
4
D. 21 / " (555.63 mm)
7
8
E. 23 / " (600.07 mm)
5
8
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer's location.
Your oven can be built into a cabinet or wall as a stand-alone
unit. It can also be installed under gas or electric wall ovens, the
SuperSteam oven models SSC2489DS & SSC2489GS or under
the cooktop models SDH3042DB, SDH3652DB, SCH2443GB,
SCH3043GB, SCR3041FB, SCR3042GB, SCR2442FB,
SCR3041GB and SCR3042FB.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1
and deburred of all sharp edges.
IMPORTANT
electrical outlet to prevent tension.
Always check electrical codes for requirements.
2
B
C
J
B
C
D
E
F. 16" (406.4 mm)
G. 14 / " (370.68 mm)
19
32
H. 1 /3 " (38.89 mm) door thickness
17
2
I. 15" (381 mm) auto drawer opening
J. 4" (101.60 mm)
Always allow sufficient power cord length to the
A A
G
I
D
H
F
1 / " diameter hole
2
G