5.5 horsepower 2400 psi 2.2 gpm high pressure washer cleaning system (48 pages)
Summary of Contents for Craftsman 580.76804
Page 1
Before using this product, read this manual and follow all its Safety Rules and Operating Instructions. Sears, Roebuck and Co., Hoffman Visit our Craftsman website: www.sears.condcmftsman Part No. 133610 Draft 2 (4/5/99) Printed in _e U.S.A. Estates, IL 60179 • Safety • Assembly •...
Page 2
LIMITED ONE YEAR WARRANTY ON CRAFTSMAN For one year from the date of purchase, when this Craftsman Cleaning System is maintained and operated according to the instructions in the owner's manual, Sears will repair, free of charge, any defect in material and - workmanship.
Page 3
• Operate engine only.at govemed speed. Running the engine at excess=ve speeds increases the hazard of personal injury. Do not tamper with parts which may increase or decrease the governed speed. • Do not wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.
Page 4
Check carton for additional loose pads. HOW TO SET UP YOUR CLEANING SYSTEM For the most part, your Craftsman High Pressure Cleaning System has been assembled at the factory. You must, however, assemble the spray gun and attach it to th_ high pressure hose.
Page 5
KNOWYOUR HIGH CLEANING Read this owner's manual and safety illustrations with your cleaning system to familiarize yourself with the locations of various controls and adjustments. Detergent and Chemical Reservoir Tanks with Filter and Baffle Adjustable Nozzle High Pressure Hose Dial-A-Cleaner Selector Knob Adjustable Nozzle - Adjust for high or low pressure;...
Page 6
Read these instructions and leam how to use your cleaning system before you attempt to start your cleaning system. If you have any problems operating your cleaning system, please call the pressure washer helpline at 1-800222-3136. How To Use the Adjustable...
Page 7
Allow detergent to 'soak in' (between 3-5 minutes) before washing and rinsing. Reapply as needed to prevent surface from drying. Wash and Rinse Surface This Craftsman Cleaning System permits regulation of output water pressure by varying the engine speed. The Pressure Command found on the front panel may be set, as follows.'.
Page 8
BEFORE STARTING THE CLEANING SYSTEM To operatethe engineyouwillneedto dothe following: Add Engine Only use high quality detergent oil rated with API service classification SF, SG or SH. Select the oil's SAE viscosity grade according to your expected operating temperature: colder 40°F <...
Page 9
Engage the safety latch on the spray gun. Attach adjustable nozzle extension onto spray gun. Move choke lever to "CHOKE" Note: If restarting a warm engine after e short shutdown, move choke lever to "RUN." • Move engine control to =ON." •...
Page 10
Maintenance Schedule Follow the houdy or calendar intervals, whichever occurs first. More frequent service is required when operating in adverse conditions noted below. Maintenance Operation Check/Clean water inlet screen I Check high pressure hose Checl<spray gun and assembly for leaks Purge pump of air end contaminants Check oil level...
Page 11
BEFORE EACH USE • Check water inlet Screen for damage. • Check high pressure hose for leaks. • Check chemical tanks and filters for damage. • Check gun and wand assembly for leaks. • Purge pump of air and contaminants. •...
Page 12
Insert wire into nozzle and turn back and forth to clear obstruction. Remove additional debris by back flushing water supply through wand. Back flush between 30 to 60 seconds. Turn wand to stream spray and move nozzle from low to high pressure while flushing. •...
Page 13
ENGINE MAINTENANCE Maintenance, replacement or repair of the emission control devices and systems performed by any non-road engine repair establishment or individual. Checking Oil Level Oil level should be checkedpriorto each use or at least every 8 hoursof operation.Keep oil level maintained.
Page 14
Should any damage be found, replace the hose. DO NOT attempt to repair a damaged hose. Replace the hose with the genuine Craftsman part. • Drain water from hose and prepedy hang it on the wire support provided on the guide handle.
Page 15
PROBLEM Pump has following problems: failureto producepressure,or erraticpressure,chattering,lose of pressure,low water volume. Detergentfails to mix. Enginerunsgood when not spraying but dies when you beginto spray. Enginewill not start;or starts and runsrough Engineshuts downduring operation Engine lacks power. CAUSE 1. Nozzle in low pressure mode- 2.
Page 17
Briggs & Stratton 6.5HP Model # 121412-0148-E1 654_ _lr REQUIRES SPECIAl-TOOLS TO INSTALL SEE REPAIR INSTRUCTION MANUAL 1019 LABEL KIT...
Page 18
Briggs & Stratton 6.SHP Model # 121412-0148-E1 190A...
Page 24
Craftsman 2500 PSI Cleaning System 580.768040 Main Unit...
Page 25
Craftsman 2500 PSI Cleaning Main Unit Description Item Part# B3608B LINK, Throttle Control B3605 DECAL, Control Panel 2500 B3376B TAG, System Flush Water B3222A CAP, Chem Container =A" B3222B CAP, Chem Container =B" B3222C CAP, Chem Container =C" B3222D CAP, Chem Container =Water"...
Page 26
BRIGGS & STRATTON CORPORATION (B&S), THE CALIFORNIA AIR RESOURCES BOARD (CARB) AND THE UNITED STATES ENVIRONMENTAL PROTECTION AGENCY (U.S. EPA) EMISSION CONTROL SYSTEM WARRANTY STATEMENT (OWNER'S DEFECT WARRANTY RIGHTS AND .OBLIGATIONS) In the interest of the environment, Briggs & Stratton engines that meet strict emission requirements are labeled, "This engine conforms to 1995-1998 California Emission Control Regulations for ULGE...
Page 27
BRIGGS AND STRATTON EMISSION CONTROL DEFECTS WARRANTY PROVISIONS The following are specific provisions relative to your Emissions Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non-regulated engines found in the Operator/Owner's Manual. 1. Warranted Parts Coverage under this warranty extends only to the parts listed below (the emission control systems parts) to the extent these parts were present on the...
Page 28
For in-home major brand repair service: Call 24 hoursa day, 7 days a week 1-800-4-MY-HOME Para pedir servicio de reparaci_n a domicilio - 1-800-676-5811 In Canada for all your service and parts needs call Au Canada pour tout le service ou les pieces For the repair or replacement parts you need: Call 7 am - 7 pm, 7 days a week 1-800-366-PART...