Table of Contents
Advertisement
1
1
1
1
2
4.3.2
Stand
Refer to
Figure 4-3
for details.
1. Remove fixation screws [4] that secure the base assembly,
pull the base assembly downwards away from the catches.
Do not release the two screws in the middle of the stand.
4.3.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Unplug all connectors from the PSU.
2. Remove the fixation screw located right side of the mains
inlet connector.
3. Remove the other fixation screws located at the corners
and/or sides of the panel.
4. The PSU can be taken out of the set now.
4.3.4
Small Signal Board (SSB)
Refer to
Figure 4-4
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Release the clamps and unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted away from side connector
cover and lifted from the set.
Mechanical Instructions
4
4
2
4
4
Figure 4-3 Rear cover removal
back to
div. table
TPM9.2L LA
2
2
3
3
Figure 4-4 SSB removal
4.
EN 11
1
M3 × 8
1
3 × 10
2
3
M3 × 4
countersunk head
3
M3 × 8
3
3
4
1
2
19260_102_120326.eps
120327
3
1
2
3
19260_103_120322.eps
120323
2012-Mar-30
Advertisement
Table of Contents
