Related Manuals for Philips BM5B/37
Summary of Contents for Philips BM5B/37
- Page 1 Always there to help you Register your product and get support at www.philips.com/support Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety 2 Your multiroom speaker Introduction What's in the box Overview of the main unit 3 Prepare Connect power and turn on 4 Play Play in single mode Play in group mode Control play 5 Other features Listen to an external device Update firmware Reset group status... -
Page 4: Important
1 Important h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Safety i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the Know these safety symbols point where they exit from the apparatus. - Page 5 Warning • Never remove the casing of this unit. • Never lubricate any part of this unit. • Place this unit on a flat, hard and stable surface. • Never place this unit on other electrical equipment. • Only use this unit indoors. Keep this unit away from water, moisture and liquid-filled objects.
-
Page 6: Your Multiroom Speaker
2 Your multiroom speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the Philips izzylink speaker, you can: • listen to music from your Bluetooth- enabled devices;... -
Page 7: Overview Of The Main Unit
Overview of the main unit abc d e f g h ij k e Volume indicator • Lights up after power-on. • Turn the speaker on or switch to Multiroom Active Mode/Standby • Dims in Multiroom Active Mode. Mode. • Flashes when the speaker is muted. - Page 8 h AUDIO IN • Audio input socket (3.5mm) for an external audio device. i SOFTWARE UPGRADE • USB socket for speaker software upgrade only. j GROUP RESET • Press with a sharp object to restore factory defaults. k DC IN •...
-
Page 9: Prepare
Always follow the instructions in » The volume indicator lights up. this chapter in sequence. » The signal strength indicators flash If you contact Philips, you will be asked for several seconds until the speaker for the model and serial number of boots up. - Page 10 Switch to Multiroom Active Mode/ Standby Mode • In single mode, press to switch to Multiroom Active Mode. » The volume indicator dims. » All the other indicators turn off. • In group mode, press on any speaker in the group to switch to Multiroom Active Mode.
-
Page 11: Play
Bluetooth device is approximately 10 meters (30 feet). Bluetooth and search for Bluetooth devices (refer to the user manual of the device). When [Philips BM5 XXX] is displayed on your device, select it to start pairing and connection. If necessary, enter the default password “0000”. -
Page 12: Play In Group Mode
• After successful Bluetooth connection, play Play in group mode music on the Bluetooth device. » Music streams from your Bluetooth Group mode: If you have more than one device to the speaker. izzylink-compatible multiroom speakers, you To disconnect the Bluetooth-enabled device: can create a group and stream music to •... - Page 13 Hold GROUP on a second speaker for Change master 3 seconds (The slave). You can change the current master in Wait for 15 to 30 seconds for connection a group easily. For example, when the setup. Bluetooth connection with the current master speaker is lost, you can set the Repeat steps 1 to 3 to add more slave closest slave speaker as the master.
-
Page 14: Control Play
Control from the speaker Switch to single mode • In single mode, turn the speaker on/off. • In group mode, turn the whole group of speakers on/ off. • In single mode, pause/resume (unavailable play of the current speaker. in AUDIO •... -
Page 15: Other Features
Note • Make sure that the USB stick is FAT16/32 formatted. On your PC/Mac, go to www.philips.com/ support. Enter the model number to find the latest firmware upgrade file available. Connect an audio cable with a 3.5 mm... -
Page 16: Reset Group Status
Do not remove the USB stick, and wait for around 3 to 4 minutes for completion of the firmware upgrade. www.philips.com/support » At completion of firmware upgrade, all indicators on the speaker flash at the same time. XXXX Reset group status XXXX. -
Page 17: Product Information
6 Product Power Consumption information - Multiroom < 2 W Active Mode - Standby Mode <0.5 W Dimensions Note - Main Unit 165 x 118 x 165 mm • Product information is subject to change without prior (W x H x D) notice. -
Page 18: Troubleshooting
If the problem remains unsolved, go to the Philips Web page (www. Bluetooth cannot be connected with this philips.com/support). When you contact Philips, speaker. -
Page 19: Understand Meanings Of Led Status
8 Understand Two indicators The signal strength of lighting up group connection is good. meanings of Only one The signal strength indicator of group connection LED status lighting up is poor. Move slave speakers closer to the master speaker. No indicator The speaker is powered lighting up off or working in single... - Page 20 Meaning Bluetooth indicator status The speaker is powered off. The speaker acts as a slave in group mode. The speaker is grouping with its master/slave. Flashing The speaker is in pairing mode. blue Solid blue The speaker is connected to a Bluetooth-enabled device.
-
Page 21: Notice
For disposal or recycling interference to radio communications. information, please contact your local authorities or visit www.recycle.philips.com. However, there is no guarantee that interference will not occur in a particular Environmental information installation. If this equipment does cause All unnecessary packaging has been omitted. -
Page 22: Written Offer
If you prefer not to use email or if you do not receive confirmation receipt within a week after mailing to this email address, please write to Open Source Team, Gibson Innovations Limited, 5/F Philips Electronics Building, 5 Science Park East Avenue, Hong Kong Science Park, Shatin, N.T. Hong Kong. - Page 24 This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.