Whirlpool ADG 8472 Quick Reference Manual

ADG 8472
Program selector knob
Mains On / Off
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Wash cycle
Pre-Rinse Washing
Programmes
Pre-Rinse
Quickwash
Normal
Intensive
1) Reference programme for energy label in compliance with
EN 50242 regulations;
2) Refer to "User instructions";
3) Program data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or below 15°C -
as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@email.whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme
Drying
end
Programme chart
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery with no
40°C
dried-on food.
1) 5)
50°C
Normally soiled crockery.
Recommended programme for heavily
5)
70°C
soiled crockery, especially suitable for
pans and saucepans.
Options
Time and failure display
Indicates in hours the time remaining until the
start of the wash cycle. Toward the end of the
programme, during the drying cycle, the display
will indicate the time remaining in minutes.
"F...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the
button, the delayed start indicator increases by 1
hour, and after 24 returns to 00. Then press the Start
button. The dishwasher will start at the set time.
Antibacterial rinse
This function adds an antibacterial rinse at the end
of the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will light up when
the function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time),
the lamp will start blinking to indicate that
sanitation is not guaranteed.
Detergent
A
-
X
X
X
4) The bacteria removal efficiency has been tested by
the Institut Pasteur de Lille (France), based on the
NF EN 13697 standard of November 2001.
5) These programmes can be used with the Antibacterial rinse
option.
(We reserve the right to make technical modifications)
GB
3)
4)
2) 3)
Consumption
B
Litres kWh Minutes
- 5.0 0.02 10
- 13.0 0.70 30
X 16.0 1.05 140
X 17.0 1.90 125
5019 396 91335
WH/I/K/GB