Table of Contents
Advertisement
Chapter 1 Maintenance
Notes for using additional processor kit after setting up Windows Server2012R2/2016.
●
1)
When fixed IP address / DNS set for the following option, please add CPU board by the following
procedure. (The procedure is necessary for fixed IP address setting after added CPU.)
N8104-173 Dual Port 10GBASE-T LOM Card
N8104-177 Dual Port 25GBASE SFP+ LOM Card
N8104-182 Dual Port 10GBASE-T Adapter
N8104-183 Dual Port 10GBASE-T Adapter
N8104-185 Dual Port 10GBASE SFP+ Adapter
N8104-187 Dual Port 25GBASE SFP28 Adapter
PCI Card with PCI-to-PCI bridge
(a). Change the setting to stop the service which is referred to these options boot automatically. In
addition, when these options connect to storage, please remove the LAN cable from these
options not to be recognized.
(b). When setting LAN teaming at these options, please cancel teaming.
(c). Record IP address of these options /sub netmask / default gateway / preferred DNS server /
alternate DNS server (the part of the following red frame.)
(d). Change the setting of these options IP address to "obtain an IP address automatically", and
change DNS address to "obtain DNS server address automatically."
(e). Follow the user's guide to add CPU board.
(f).
Set IP address/sub netmask/ default gateway/ preferred DNS server/ alternate DNS server,
which is recorded in these options procedure C.
(g). Set LAN teaming again.
(h). Set up service which is changed setting by procedure a to boot automatically again. When
connect these options with storage, connect LAN cable again to recognize the storage.
2)
When refer to network of ESMPRO/ServerManager, duplicate network card will be displayed after change
CPU processor kit configuration. Please ignore the network device which are not displayed on OS, the
detail information of its network device will be displayed "Unknown".
Tips
If it doesn't follow above procedure, it will display a message as fixed IP address is
using by other device and cannot set up fixed IP address.
In that case, please do the below command on command prompt window, and start
the boot device manager. Please click [View] - [Show hidden devices] and expand
network adapter tree, and then delete the gray nonpresent device.
>set devmgr_show_nonpresent_devices=1
>Start DEVMGMT.MSC
Express5800/R120h-1M, R120h-2M (2nd-Gen) Maintenance Guide
5. Troubleshooting
63
Advertisement
Table of Contents
