7
Pass a new shutter.
8
Reinstall the shutter and the slider
cover using the reverse of the above
procedure.
n
NOTE
Do not fully tighten the screws to secure the
shutter on the end block side at this time.
Fully tighten these screws after adjusting for shutter
looseness in Step 9.
9
Secure the shutter.
Tighten the screws while pulling on the
shutter with your fingers so that there is no
looseness in the shutter.
4
c
CAUTION
Do not press down on the shutter with excessive
force.
Pressing down hard on the shutter may cause the
shutter to warp.
4-2
Step 7
Replacing the shutter
53403-A1-00
Shutter
Step 9
Adjusting the shutter looseness
53404-A1-00
Shutter passing portion