Pioneer SA-1060 Operating Instructions Manual

Operating
Instructions
STEREO AMPLIFIER
A-1060
Photograph shows BLACK finished model.
Thank you for buying this Pioneer product.
Please read through these operating instructions and then you
will know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In accordance with the power and voltage requirements of dif-
fering areas, the following model names are used to designate
models with differing electrical specifications.
Models
I
HE, HEZ, NE,
NEZ
WE, WB, WP | a.c. 220—240 volts ~
S, S/G, SS AC 110, 120, 220, 240 volts (Switchable voltage)
Line voltage
a.c. 220 volts ~
D, D/G AC 120, 220, 240 volts (Switchable voltage)
R, R/G | AC 110—120, 220—240 volts (Switchable voltage)
KU, KC AC 120 volts
YP, YB
HB, HP a.c. 240 volts ~
NOTES:
e The model names are stamped on the packing case.
e These operating instructions are prepared on the basis of the KU
model, and they can be used for other models. Although the
design of the power plug and the power outlet shown may differ
from the actual one, the operating procedures are the same.
WARNING: To preveENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CONNECTIONS. 20... .ccceseeceeeeentereresseenreraeteeees
PANEL FACILITIES
OPERATIONS
- CONTENTS
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch.
U.S.A., Canadian, European, U.K., and Australian models are
not provided with this switch.
You will find the line voltage selector switch on the rear panel. This
switch has positions for 110 V, 120 V, 220 V and 240 V power sources.
Before your model is shipped from the factory, the switch is set to the
power requirements of the destination; nevertheless, you should
check that it is set properly before plugging the power cord into the
AC outlet. If the voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector switch as
follows. Before adjusting disconnect the power cord.
1. Provide yourself with a medium size flat tip screwdriver.
2. Insert the screwdriver into the arrow on the voltage selector and
adjust so that the tip of the arrow points to the voltage value of
your area.
VOLTAGE SELECTOR
120V 240V
Medium size screw driver
IMPORTANT NOTICE [For U.S.A. and
Canadian models]
The serial number for this unit is Jocated on the rear panel.
Please write this serial number on your enclosed warranty card
and keep in a secure area. This is for your security.
SPEGIFICATIONS. ii dec cvs woe ces ae ata ais tee ven sais sas ones 9
TROUBLESHOOTING ...........cceececeer eens ee eee eee 10
QMPIONEER'