Pioneer SA-1040 Operating Instructions Manual

Operating
Instructions
STEREO AMPLIFIER
A-1040
Thank you for buying this Pioneer product.
Please read through these operating instructions and then
you will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
These operating instructions are based on the model KU, and
they can be used for the KC, YP, S and S/G models. The dif-
ferences between the models are given below.
KU and KC models:
For U.S.A. and Canada ('KU' or 'KC' stamped on packing
case): power line voltage is AC 120 volts.
YP model:
For Australia ('YP' stamped on packing case): power line
voltage is a.c. 240 volts ™
S and S/G models:
For destinations excluding above ('S' or 'S/G' stamped
on packing case): A 4-point (a.c. 110 V/120 V/220 V/
240 V) voltage selector switch is provided.
IMPORTANT NOTICE
[For KU and KC models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.
The KU and KC models do not have a LINE VOLTAGE
SELECTOR, therefore power line voltage cannot be chang-
ed.
Rear Panel Facilities and Connections ......
Connection Diagram ..........ccscveaeeseceeees
Power Cord Connection .......... aeeeaeneusens
Front Panel Facilities ...............ssssssseeeees
CONTENTS
LINE VOLTAGE SELECTOR SWITCH
Only S and S/G models are provided with this switch but
KU, KC and other model YP are not provided with this
switch
You will find the line voltage selector switch on the rear
panel. This switch has positions for 110 V, 120 V, 220 V and
240 V power sources. Before your model is shipped from the
factory , the switch is set to the power requirements of the
destination; nevertheless, you should check that it is set pro-
perly before plugging the power cord into the AC outlet. If
the voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector
switch as follows. Before adjusting disconnect the power
cord.
1. Prepare a medium size screwdriver.
2. Insert the screwdriver into the arrow on the voltage selec-
tor and adjust so that the tip of the arrow points to the
voltage value of your area.
120V 240V
WARNING: TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
Operation .........cccceessccusueueeeseusecueneuss
Using a Tape Deck ............ccceseeeneereaeees
Troubleshooting .......cseccceseescenseeeeesens
Specifications .......cccccccececseeeeeaeennecues