Checking Lift Arm and Rear Cutting Unit Clearance
(continued)
A lack of clearance at the front plate bracket could damage the lift arms.
3. At the rear cutting unit, measure the clearance
between the wear strap on the top of the rear
cutting unit wear bar
.
Note:
mm (0.02 to 0.10 inch)
not in this range, adjust the cutting unit lift
cylinder.
A lack of clearance at the rear wear bar could damage the cutting unit.
4. Start the engine, lower the cutting units, shut off the engine, remove the key, and wait for
all moving parts to stop.
Adjusting the Lift-Arm Clearance
1. At each side of the machine, loosen the jam
nuts
Setup: Adjusting the Lift Arms
and the bumper stop
The correct clearance is 0.51 to 2.54
. If the clearance is
and back off the lift arm-stop bolts
IMPORTANT
G402585
IMPORTANT
.
G402586
Page 3–13
3466-297 A