Advertisement
Available languages
Available languages
Mounting the Lens
Suitable lenses
The lens must be a C mount type, and the screw thread must not project
more than 9 mm (3/, inches) from the lens mounting surface.
Lens mounting surface
y
9mm
"i
This camera uses a 1/2-inch CCD, so the lens should be for use with this
size of CCD. in particular, if used with a lens for a 2/3-inch CCD the angle
of view will be different.
Plug fitting for an auto-iris lens
The camera is supplied with a plug to fit the LENS connector. To connect
an auto-iris lens, first replace the plug on the lens cable with the plug
supplied.
1 Solder the lens cable wires to the pins on the plug supplied; apply heat
after putting heat shrink sleeving on the wires. The pin assignment is as
fotlows.
:
Pin 1: Power supply (+9 V DC, 50 mA)
Pin 2: Unused
Pin 3: Video signal output (for auto-iris control; 0.7 Vp-p, 40 k ohms, no
synchronizing signal)
Pin 4: Ground
(Refer to the operation manual for the lens to determine the cable color
coding.)
13
Advertisement
