Husqvarna K1270 II R Operator's Manual page 14

5. If it is necessary, replace the spark plug.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
Starter housing
WARNING:
always use eye protection when you replace
the recoil spring or the starter rope. There is
tension in the recoil spring when it is wound
in the starter housing. The recoil spring can
eject and cause injury.
To remove the starter housing
1. Loosen the 4 screws on the starter housing.
2. Remove the starter housing.
14
Always be careful and
To replace a damaged starter rope
1. Pull out the starter rope approximately 30 cm (A).
A
C
2. Hold the starter rope pulley (B) with your thumb.
3. Put the starter rope in the notch (C) in the starter
pulley .
4. Put the starter rope around the metal sleeve.
B
1390 - 001 - 10.01.2020