Husqvarna K1270 II R Operator's Manual page 6

move back to their initial positions. This function locks
the throttle trigger at idle speed.
B
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
2. Push the throttle trigger lockout and make sure that it
goes back when you release it.
6
3. Make sure that the throttle trigger and throttle trigger
A
4. Start the product and apply full throttle.
5. Release the throttle control and make sure that the
6. If the cutting blade rotates at idle position, adjust the
To do a check of the stop switch
1. Start the engine.
2. Push the stop switch to the STOP position. The
Vibration damping system
Your product is equipped with a vibration damping
system that is designed to minimize vibration and
make operation easier. The product's vibration damping
system reduces the transfer of vibration between the
engine unit/cutting equipment and the product's handle
unit.
lockout move freely and that the return springs
operate correctly.
cutting blade stops and stays stationary.
To adjust the idle speed on page
idle speed. Refer to
18 .
engine must stop.
1390 - 001 - 10.01.2020