Advertisement
Fig.
| The machine must be perfecthy level with
all four feet standing on the floor. br must
nat wobble.
> Пее a spirit level to align the machene on
all sies.
if necessary, correct the height of the
machine's
feat
1. Lindo the lack nuts
2. Adjust the height of the teet.
3. Tighten the lock nuts again firmby to an-
sure that the feet remain at tha same
мезі.
Water supply
ғо. 06030
For ihe water connection a standard cold-
water ling with a minimum vates pressure
of 0.1МРа is required (with tap full OM, ап
least B litres of water must flow out in ang
minute).
Hf tha water pressure
exceeds
TMIPa, а pressure reducing үйіме must ba
added
| Never connect the machine to the mixer
tap of а pessureless holwater heater. И!
in doubt have the machine connected by
a specialist.
I Caution! Connections
are under Tull water
pressure; check for beaks with tap turned
fully ОМ.
| Tha filters at the free end of the inlet hose
and at the back of tha machine should only
Ба removed for cleaning purposes,
| To acid water damage the tap must be
turned OFF after using the machina.
I Tha plastic nuts on the hose connections
rust oniy be tightened
by hand.
Water supply Installation
М you use Chinese style water inlet pape,
water connection see fig. 603, 2, 48
Plaase observe the following install steps
caretully.
2. Unscrew
the sealing ring' from 2 revolu-
Tenens.
3. об
the four сему,
4. Press tha main joint against the tape with
force, than fix the screws simultangously,
Б. Screw the sealing inga upward to make
the connection tight and proof.
6 Fix the and
of the ріреб on the connoc-
tion pipa of the alectrovalve
7. Push down the block ring2, fix the pipe
onto the water tane.
B. Open the tape at the Max, position, check-
ing if there із апу water leakage. H any
water laakaga, then you should assemble
it again
9. The main joint can be apart fram the pipe
gasily. It is nat necessary
to drsassemble
the mæn joint from the water tape.
The edge
of the water tape must be even.
Drainage
ud Yn
| Whan installing the machine, de nat kink
ihe drain hose or pull
on 11.
1 When draining inte а sink the drain hose
must not be allowed to slip out of the sink
and fall anto the floor, To prevent flooding
ensure that
the water is draining fast
enough out of the sink and that the plug is
nel restricting
the outflow.
installation
see Fig. (9.
Electrical Connection
1 Thé machinae must only ba connected to
an alternating current supply ма a correctly
installed багым socket.
| The voltage indicated on the rating plate at
ihe back
of the machine must match the
mema voltage at the installation location.
| Connected load and required
fuse or lina
protecting cut-out are indicated on the rat
-ng piste.
Iit must be ensured that the plug and socket
match, that the conductor cross-section is
стел
and that the earthing system has
been installed in compliance
with regula-
Tons.
Е Multiple plug connectors
and extension
cables must
not be used.
| По not connect
the machine to electrical
outlets while your hands are wet or damp.
| fan earth leakage (ground fault protection)
gireun breaker is to be used, it must
be the
circuit breaker with symbol Ex] as this is
the опу type which complies with current
I To remove the plug from the socket, grasp
Et PUR ILIO DOR RA, DRS
UE
е cable.
Advertisement
