Powering The Monitor On/Off - Silvercrest TARGA Visionary LCD 24-9 Wide User Manual And Service Instructions

easily accessible.
3. Toggle the main power switch (7) on the back panel of the
device to On (position "I").
Connecting the Audio Cable
1. Insert the blue connector of the audio cable into the blue input
port (9) of your SilverCrest LCD 24-9 Wide.
2. If you want to listen to the sound generated by the PC through
the built-in speakers of your monitor, insert the green connector
of the audio cable into the green port on the back panel of your
PC. If necessary, read the User's Manual for your PC.
Connecting the Signal Cable
Depending on the graphics adapter of your PC and the desired
transmission type, you can transfer the picture signal from the PC
either to the DVI input (10) or the VGA input (11) of your SilverCrest
LCD 24-9 Wide. If your computer has a DVI signal output it is
recommended that you use this one instead of the VGA port, as DVI
offers a higher picture quality.
1. Insert one end of the supplied DVI cable into the DVI output
port of your PC and the other end into the DVI input port (10) of
your SilverCrest LCD 24-9 Wide.
OR
1. Insert one end of the supplied VGA cable into the VGA output
port of your PC and the other end into the VGA input port (11)
of your SilverCrest LCD 24-9 Wide.

Powering the Monitor On/Off

Powering On
1. First toggle the main power switch (7) to the On (position "I").
2. Press the 1 POWER button (6) on the front panel of the device
SilverCrest LCD 24-9 Wide
109