Panasonic SC-HC57 Owner's Manual page 17

Remote control
The remote control doesn't work properly.
≥ The remote control and this unit are using a different code.
( right, "REMOTE ")
Messages
The following messages or service numbers
may appear on the unit's display.
"--:--"
≥ You plugged the AC power supply cord in for the first time or
there was a power failure recently. Set the time (
"ADJUST CLOCK"
≥ Clock is not set. Adjust the clock accordingly.
"ADJUST TIMER"
≥ Play timer is not set. Adjust the play timer accordingly.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and will
shut down in a minute. Press any button to cancel it.
"CANNOT SET"
≥ Select an audio source other than "([SC-HC57]) AIRPLAY" or
"VTUNER".
"CHECKING CONNECTION"
≥ The unit is checking the connected iPod/iPhone. If this
display keeps appearing, make sure that iPod/iPhone is
inserted correctly and try again (
"ERROR"
≥ Incorrect operation is performed. Read the instructions and
try again.
"F61"
≥ There is a power supply problem. Consult the dealer.
"ILLEGAL OPEN"
≥ Sliding door is not in correct position. Turn the unit off and on
again. If this display appears again, consult the dealer.
11).
8).
"NODEVICE"
≥ The iPod/iPhone device is not inserted correctly. Read the
instructions and try again (
"NO DISC"
≥ Insert the disc to be played (
"NO PLAY"
≥ A CD that is not in CD-DA format is inserted. It cannot be
played.
"NOT SUPPORTED"
≥ You have inserted an iPod/iPhone that cannot be played
( 4).
≥ Insert correctly and try again if iPod/iPhone is compatible.
"READING"
≥ The unit is checking the CD information. After this display
has disappeared, start operating.
"START ERROR"
≥ Check the iPhone/iPod touch.
Visit the below website for more information:
http://radio.vtuner.com/panasonic/en/
"REMOTE " (" " stands for a number.)
≥ The remote control and this unit are using different codes.
Change the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK] and
[4] for more than 4 seconds.
– When "REMOTE 2" is displayed, press and hold [OK] and
[3] for more than 4 seconds.
[SC-HC57] "NOCONNECT"
≥ This unit cannot connect to the Internet.
Check the Internet connection.
[SC-HC57] "DL ERROR"
≥ The software download has failed. Press any button to exit.
Please try again later.
≥ The server cannot be found. Press any button to exit. Make
sure that the wireless network is connected to the Internet.
[SC-HC57] "FAIL"
≥ Updating or setting has failed. Read the instructions and try
again.
[SC-HC57] "LEVEL 0"
≥ There is no link between this unit and the wireless network
router.
Try the following operations:
– Check that the wireless network router is turned on.
– Turn this unit off and on again.
– Reset the wireless network settings. (
If the problem persists, consult your dealer.
8).
8).
12)
17
RQT9633