Table of Contents
Advertisement
Appliance door
en
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
The rail must sit between the two bars (fig.
1.
Push the retainer at the back in between the lower
2.
and the upper bar (fig.
Push on the "PUSH" tab and swing the rail in so that
3.
the retainer ends up between the two bars (fig.
Release the "PUSH" tab; the retainer will hook into
4.
place (fig.
). Then pull the rail out as far as it will go
$
and slide it back in.
24
).
!
).
"
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Main oven – Fitting and removing the glass
panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Locking the appliance door
Open the appliance door fully.
1.
Open the two locking levers on the left and right
2.
(fig.
).
!
Close the appliance door as far as it goes (fig.
3.
).
#
Removing panels
Press the left- and right-hand sides of the cover
1.
(fig.
).
!
Remove the cover (fig.
2.
Lift out each panel (fig.
3.
carefully on a flat surface.
If necessary, you can remove the condensate trough
4.
for cleaning. To do this, open the appliance door
fully (fig.
).
"
) and set them down
#
).
$
).
"
Advertisement
Table of Contents
