Kenwood GE-600 Instruction Manual page 2

Important!
Europe, Australia and U.K.
Units shipped to Europe are designed for operation on
220 volts AC. Units shipped to Australia and U.K. are
designed for operation on 240 volts AC.These units
are not equipped with an AC voltage selector switch
and the discussion of such a switch that follows should
be disregarded.
All other countries
Units shipped to countries other than the above coun-
tries are equipped with an AC voltage selector switch
on the rear panel.
Refer to the following paragraph for the proper setting
of this switch.
AC voltage selection
This unit operates on 110-120 volts or 220-240 volts
AC. The AC voltage selector switch on the rear panel is set to
the voltage that prevails in the area to which the unit is ship-
ped. Before connecting the power cord to your AC outlet,
make sure that the setting position of this switch matches
your line voltage. If not, it must be set to your voltage in
accordance with the following direction.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
2 GE-600
AC 110-120V~ <a> AC 220-240V~ AC 110-120V~ ab AC 220-240V~
This shows switch
lever is locked in
220-240V~
position.
This shows switch
lever is locked in
110-120V~
position.
Move switch lever to match your line
voltage with a small screw driver or other
pointed tool.
AC voltage selector switch
For United Kingdom
The mains plug must be removed from the wall socket
prior to any internal examination.
Important
The wires in this mains lead are coloured in accordance
with the following code:
BlU Cee sin. gro alate cent vnteoteenpted ode Neutral
BOW ng.c oes enevieneeroutect de eek Live
The wires in this mains lead must be connected to the
terminals in the plug as follows:
Wire colour Plug terminal marking
Blu Gas 2 Asiiesed cd Aes latieeesins N or Black
BIOWM tides aroevdiadecathaeasenae: L or Red
| CS E
Brown to als See
Live |
Blue to _ L
Neutral
| Plug ——|—
\ a
Notes:
1) 1f a 13-amp plug is used, this must be fitted with a 5-amp
fuse.
2) If a 3-pin plug with earthing contact is used, no wire must
be connected to the E terminal.