Table of Contents
Advertisement
5 Troubleshooting
Issue
The Latch Bolt does
not operate correctly
after installation.
After installation, the
Latch Bolt makes sounds
but does not work.
The door handing is not
activated after the
batteries are installed.
The lock turns in the
wrong direction.
Cannot pull out the key
from the Keyhole.
The lock rotates only if
the Key is inserted.
The lock does not smoothly
lock or unlock while using
the Thumb Turn.
Make sure the backset on the Latch Bolt is set to the proper
length. Refer to page 8.
Make sure before installation the Latch Bolt is retracted. Refer to
page 9.
Please restore to the factory default setting and enter the default
Master PIN Code to set up the lock. Refer to page 14.
Ensure you have followed the installation instructions. Re-install
and reset the lock by paying attention to the following tips:
Before installing the Exterior and Interior Assembly, make sure the
Latch Bolt is fully retracted (in the unlocked position).
Do not insert the key when you are installing.
Ensure you have inserted the cable connector of the Exterior
Assembly to the socket on the Interior Assembly correctly.
Keep the Exterior and Interior Assembly aligned and parallel to
the door edge, and the Latch Bolt parallel to the door edge.
Press and hold the Reset Button for at least 5 seconds until you
hear a beep.
Use new 4 AA dry batteries, do not use rechargeable batteries, or
new batteries mixed with old batteries.
Press the Reset Button for at least 5 seconds until you hear the
tone prompting you to restore the default settings.
Press and hold the Reset Button for at least 5 seconds until you
hear a beep to activate the lock-handing process.
If resetting fails to solve it, the lock is probably not installed
correctly. Please re-install the lock and reset it again.
Disassemble the lock, then rotate to pull out the key and re-install
the lock.
Do not insert the key when you are installing.
Make sure the Latch Bolt is installed correctly. Refer to page 8-9.
Con�rm the Mounting Screws are properly installed.
Solution
21
Advertisement
Table of Contents
