Huawei USG6000E Series Quick Start Manual page 24

HUAWEI USG6000E Series Quick Start
Figure 2-17 Appearance and auxiliary materials of the USG6635E, USG6640E-K,
USG6655E
Cable Connection
Connect cables according to
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for configuration.
Issue 02 (2022-08-22)
NO TE
● By default, 40GE optical interface 40GE0/0/1 is unavailable. To use it, run the set device
port-config-mode 40g-port enable command to enable it. However, after that, 10GE
optical interfaces numbered XGE0/0/8 to XGE0/0/11 become unavailable.
● The power cable varies according to the delivery country.
Copyright © Huawei Technologies Co., Ltd.
2 Device Introduction and Cable Connection
Figure 2-18 and power on the device. As device does
21