Adding Fuel; Performing Daily Maintenance; Breaking In A New Machine - Toro 74943 Operator's Manual

Riding mower with 48in, 52in, 60in, or 72in turbo force mower
Hide thumbs Also See for 74943:
Table of Contents

Advertisement

Adding Fuel

Recommended Fuel
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 87 or higher ((R+M)/2 rating method).
Ethanol: Gasoline with up to 10% ethanol
(gasohol) or 15% MTBE (methyl tertiary butyl
ether) by volume is acceptable. Ethanol and
MTBE are not the same. Gasoline with 15%
ethanol (E15) by volume is not approved for use.
Never use gasoline that contains more than
10% ethanol by volume, such as E15 (contains
15% ethanol), E20 (contains 20% ethanol), or E85
(contains up to 85% ethanol). Using unapproved
gasoline may cause performance problems and/or
engine damage which may not be covered under
warranty.
Do not use gasoline containing methanol.
Do not store fuel either in the fuel tank or fuel
containers over the winter unless you use a fuel
stabilizer.
Do not add oil to gasoline.
Using Stabilizer/Conditioner
Use fuel stabilizer/conditioner in the machine at all
times to keep the fuel fresh longer when used as
directed by the fuel-stabilizer manufacturer.
Important:
Do not use fuel additives containing
methanol or ethanol.
Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer.
Filling the Fuel Tank
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Clean around the fuel-tank cap.
5.
Fill the fuel tank until the fuel gauge reads at the
full mark
(Figure
Note:
Do not fill the fuel tank completely full.
The empty space in the tank allows the fuel to
expand.
7).
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page
37).

Breaking in a New Machine

New engines take time to develop full power. Mower
decks and drive systems have higher friction when
new, placing additional load on the engine. Allow
40 to 50 hours of break-in time for new machines to
develop full power and best performance.
18
Figure 7
Maintenance
g027726

Advertisement

Table of Contents
loading

Table of Contents