Adjusting The Anti-Scalp Rollers - Toro 74943 Operator's Manual

Adjusting the Anti-Scalp
Rollers
For Machines with Side Discharge
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
31, Figure 32, and
Figure 31
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 32
1. Anti-scalp roller
2. Bushing
Figure
Figure 33.
4. Flange nut
5. Bolt
3. Flange nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing
Adjusting the Anti-Scalp
Rollers
For Machines with Rear Discharge
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
g029955
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
34 and Figure
g029956
30
Figure 33
4. Flange nut
5. Bolt
35.
g029957
Figure