Table of Contents
Advertisement
2.7 Remove the Base Assembly
for VESA Mounting
Before you start disassembling
the display base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. Loosen the assembly screws, then
detach the neck from the monitor.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact the manufacturer for wall-
mount installation.
100mm
100mm
Warning
This product is a curve design, when
attaching/detaching the base, place the
protective material under the monitor
and, to avoid damage, do not press
down on the monitor.
* Display design may differ from those
illustrated in this manual.
Warning
•
To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
•
Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
22
0°
-5°
90°
Advertisement
Table of Contents
