Philips DC612 Operating Instructions Manual page 17

This set can be equipped with a wire remote control allowing you to carry out some of the main functions
of the set. Thanks to the large buttons and ergonomic design, you can easily control the set without the
need to take your eyes off the road while driving. This gives you increased security.
© The following functions are available :
Radio : Search tuning up
CDC : SP: Next track
LP : Fast forward
Radio : Search tuning down
CDC : SP: Previous track Ns
LP : Fast backward
NOLUME
Radio : Preset up
."
Audio: Volume up ~ <= Audio : Source selection
Legend : SP - Short press
LP - Long press (>2 seconds}
mw INSTALLING REMOTE CONTROL
Fixing remote control (Fig. 7)
The remote control has to be fitted in a position which is easily accessible by a natural movement,
either on the dashboard or between the two seats.
The remote control, or its cable, must in no way interfere with normal
A use of the steering wheel! Never mount the remote control on the
steering wheel itself!
¢ First fix the support temporarily using the adhesive tape. You can then check for ease of use in
that position.
¢ After you have determined the ideal position, fix the remote control as follows:
- Fix the metallic support using the supplied screws. Then slide the remote control
into its support. For security reasons always leave the remote control fitted in
its support!
Connecting remote control (Fig. 8)
e Determine the best way to pass the cable through or below the console. This depends on the
location of the remote control and the configuration of your car.
© If you need to drill a hole, the required diameter is 8 mm. Be careful not to drill into any existing
wiring! Protect the remote control cable from sharp edges. Use a rubber grommet if necessary.
© Insert the 2 miniconnectors into positions [A2] and [A3] of connector A.
If you later want to disconnect the remote control, do this by disconnecting the intermediate
connector G.
© Fix the remote control cable with adhesive tape underneath the carpet.
Run the cable in such a way that you cannot tread on it and that it does not get in the way when driving!
7