Configuration Status; Ip Address; Configuring Wired Network Settings In Advanced Mode; Configuring Wireless Device Settings (Optional) - Hitachi 32HXT16U Instruction Manual

Configuration Status

This section displays the status of the connection.
Select Connected if you want to activate connection.
Select as Not Connected to end an active connection.

IP Address

If an active connection is available, the IP address will
be displayed on this section. If you want to configure
IP address preferences, press GREEN button and
switch to the advanced mode.
Configuring Wired Network Settings in
Advanced Mode
After pressing GREEN button, Advanced mode will
be available. While in Advanced Mode, press RED
button to edit settings. When finished, press OK to
save, Press RETURN/BACK to cancel.
Configuring Wireless Device Settings
(Optional)
To use your TV with your wireless network, you need
a dedicated wireless USB dongle which is available
from your dealer.
Wi-Fi feature can be used for a wireless network
connection. The feature is used for infrastructure
purposes only, such as connecting to the web, hbb
sites and connecting with DLNA servers (optional). If
you have the dedicated Wifi Dongle (sold separately),
select Network Type as Wireless Device to start
connection process.
To enable Wi-Fi feature, profiles should be configured
properly. Please plug in the Wi-Fi dongle (sold
separately) to one of the USB ports.
Press YELLOW button to scan wireless network from
network settings menu. Afterwards, available network
list will be displayed. Please select your desired
network from the list.
If the selected network is protected with a password,
please enter the correct key by using the virtual
keyboard. You can use this keyboard via navigation
buttons (Left/Right/Up/Down) and OK button on the
remote control.
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
Wait until the IP the address is shown on the screen.
This means that the connection is now established.
To disconnect from a wireless network, you should
highlight Configuration Status and press OK.
You can navigate between menu tabs by pressing left/
right buttons. The help bar on the bottom of the dialog
shows features that you may use. Press BLUE button
to check your internet connection speed.
You can check the signal strenght by using the network
settings menu for the wireless device mode.

Information

Configuration Status: Displays wi-fi status as
connected or not connected.
IP Address: Displays the current IP address.
Network Name: Connected networks' name will be
displayed.
Press GREEN button to switch to advanced mode
and then press OK button to edit settings.
English - 20 -