Table of Contents
Advertisement
(4) Replace the glass and fan cover in their original position, and fasten the screw.
°
°
°
°
°
°
O°
°
fe)
Oo
Printing cutout
@ Cleaning the underside glass
(1) Turn the unit over, then pushing in the direction of the arrow ©, lift up the glass as
shown.
(To remover the underside glass cover, it is not necessary to remove any
screws.)
(2) Carefully wipe the inside surface of the glass. If there is any dust on the surface of
the liquid crystal unit, remove it carefully.
(3) Replace the glass, ensuring that the printing cutout is at the bottom, as shown below.
Push it fully into place in the direction shown by the arrow.
Printing cutout
37
Advertisement
Table of Contents
