Bosch APC-AMC2-4R4CF Installation Manual page 18

Access modular controller 2
Hide thumbs Also See for APC-AMC2-4R4CF:
Table of Contents

Advertisement

18
en | Introduction
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Docking port for compact flash memory
11. Configurable RS-232 host interface (ribbon cable connector)
12. Configurable 10/100 Mbit/s Ethernet interface
2020-01 | V02 |
4
Reset push button - reachable through the casing using a screwdriver
5
Liquid Crystal Display
6
Push button, available on top of the housing, to select different display modes
7
Jumper: Equalization of potential between different systems and earth ground
(shield)
8
Jumper: Interface selector RS-485 host connection, RS-485 two wire or RS-485 four
wire (depends on external wiring)
9
Configurable RS-485 host interface
10
Docking port for compact flash memory
11
Configurable RS-232 host interface (ribbon cable connector)
12
Configurable 10/100 Mbit/s Ethernet host interface
Internal tamper contact
DIL switch for RS-485 address selection protocol
Lithium battery for buffering of static RAM and real time clock (RTC). The battery life is
estimated at 10 years, nevertheless an error message is generated if the voltage sinks
below a preset minimum level.
Reset push button - reachable through the casing using a screwdriver
Liquid Crystal Display
Push button, available on top of the housing, to select different display modes.
Jumper: Equalization of potential between different systems and earth ground (shield)
Jumper: Interface selector RS-485 Host connection, RS-485 two wire or RS-485 four wire
(depends on external wiring)
Configurable RS-485host interface
1
Jumper: Equalization of potential between different systems and earth ground
(shield) using this interface to connect the host or extensions.
2
DIL switch for host settings.
3
Configurable 10/100 Mbit/s Ethernet interface
4
Docking port for micro SD memory card
5
Liquid Crystal Display
6
Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2-4R4 internal power supply ("wet" mode).
7
Push button, available on top of the housing to select different display modes.
8
Jumper: Potential equalization between different systems and earth ground (shield)
for the bus systems.
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ads-amc2-4r4cf

Table of Contents