Advertisement
@ Recording is possible only with Deck 2.
@When
recording important selections, be sure to make a pre-
liminary
test to ensure
that
the desired
material
is being
properly recorded.
@The VOLUME
and GRAPHIC
EQUALIZER
controls may be
adjusted
without
affecting the recording
level of the input
signal.
SYNCHRONIZED
RECORDINGS
This is done when
recording from
records to tapes, the start/
pause
play
operations
of the
RP-207H
is synchronized
with
of the start/pause recording operations of the deck.
e Switch on all units.
DOLBY NR
OFF
ON
When
recording
with
DOLBY
NR,
set
the
DOLBY
NR _ switch
to
insert a cassette into the
the ON position.
cassette compartment
of
If not, set to the OFF
Deck 2.
position.
SYNCHRO
Si
FPR
RECORD
LEVEL
°
5.
lo
|
—>
—
-
;
Press
the
SYNCHRO
Adjust
the
RECORD
button on the RP-207H
LEVEL
control
to
the
and
start
playing
the
"5" position.
record,
e The deck will be released
from
the stand-by mode
at the same time that the
record begins playing and
recording will begin.
Note:
Temporarily Stopping Synchronized Recording
At the same
time
the stylus feaves the record, the deck's
AUTO
SPACING
mechanism
is activated
and an approxi-
mately
4 second
space
is automatically
recorded
onto the
tape. Then the deck is set to the recording stand-by mode.
When
the CUE button is pressed again, at the same time the
record is resumed being played, recording also starts.
The record wil! continue playing, however, the tape will be
set to the recording stand-by mode.
When
the
> button
is pressed,
the deck
will be released
from the stand-by mode and recording will be resumed.
Pressing the ™ button
will not stop playing of the record.
[E| 21
red
Advertisement
