Transferring The Configuration To More Than One Inverter Using Quick Store - Toshiba PWU003Z Instruction Manual

Multi-loader parameter writer

Hide thumbs Also See for PWU003Z:

Table of Contents

5.3. Transferring the configuration to more than one inverter using Quick Store

This procedure describes how to use the Quick Store function (see section 6.4) to duplicate configurations.

The user must already have:

-Loaded the inverter configuration file (*.CFG) onto the Parameter writer (see section 5.1)

-Generated the configuration file using PCM software and loaded this file onto the Parameter writer

(filename1, filename 2, etc.)

STEP

• Turn the parameter writer on pressing the Power ON/OFF button for 2 seconds (see section 3.2).

• Connect the Parameter writer to the inverter using the RJ45 cable (see section 4.2).

• Press "ENT" when the screen displays "Main menu / Action".

• Press "ENT" when the screen displays "Action Config / MLD -> Device".

• The connection destination is searched. It may take one minute or more. If no inverter is

connected, a message "No device / connected" appears on the screen.

• Select the file to be transferred using the arrow keys and press "ENT" to start the transfer (see

section 6.7).

(If some folder exists in the SD card, the folder name is displayed. When selecting the folder

using the arrow keys and press "ENT", the user can access the file in the folder.)

• The configuration has been transferred successfully from the Parameter writer; disconnect the

RJ45 cable from the inverter.

• Connect the Parameter writer to the next inverter, then press the Quick Store key.

• "Store Config Successful" : The configuration has been loaded successfully onto the second

inverter; remove the RJ45 cable from the inverter.

• This action can be carried out as many times as necessary.

Note :

• Keep on pushing ESC key if the process of searching communication mode is canceled.

• Display is changed faster by keeping on pushing

• When the user is selecting the file, the folder "System Volume Information" may be displayed. It is a hidden folder

that is automatically created when SD card is connected to PC. It does not affect configuration transfers.

Transfer

key.

-15-

E6581680

Table of Contents