Automatic Transmission Fluid - Suzuki Jimny 2022 Manual

INSPECTION AND MAINTENANCE
Loosen
Tighten
60G160S
NOTICE
• When installing the spark plugs,
screw them in with your fingers to
avoid stripping the threads.
Tighten the spark plugs with a
torque wrench to 17.5 Nm (1.7 kg-
m, 12.9 lb-ft). Do not allow contami-
nants to enter the engine through
the spark plug holes when the
plugs are removed.
• Never use spark plugs with the
wrong thread size.
9-33
"a"
55RH07004
Spark plug gap "a":
For Hong Kong and Macao model:
IKR6G11
1.0-1.1mm (0.039-0.043 in.)
Except for Hong Kong and Macao
model:
KR6A-10
0.95-1.05mm (0.037-0.041 in.)
NOTICE
When replacing spark plugs, you
should use the brand and type speci-
fied for your vehicle. For the specified
plugs, refer to "SPECIFICATIONS"
section in the end of this book. If you
wish to use a brand of spark plug
other than the specified plugs, con-
sult an authorized SUZUKI dealer or a
qualified workshop.
Automatic Transmission
Fluid
Specified fluid
Use an automatic transmission
SUZUKI ATF3317 or Mobil ATF3309.
Fluid level check
When checking the automatic transmission
fluid level, perform it when the fluid tem-
perature is 70 to 80 °C (158 to 176°F).
If the fluid temperature can not be mea-
sured, ask an authorized SUZUKI dealer
or a qualified workshop for this job.
NOTICE
Driving with too much or too little
fluid can damage the transmission.
You must check the fluid level with the
automatic transmission fluid at normal
operating temperature.
To check the fluid level:
1) To warm up the transmission fluid, drive
the vehicle or idle the engine until the
engine coolant temperature light (blue
color) goes off.
2) Then drive for ten more minutes.
80TS - 01E
fluid