Table of Contents
Advertisement
3.
Press and hold the recovery key button. While holding the recovery key button,
power on the system, and continue to hold the recovery key button for two seconds,
then release. The BOXER-8651AI should then enter recovery mode.
4.
To check if device is in recovery mode, enter the lsusb command in the terminal
on the Host PC.
$ lsusb | grep "0955:7523"
If successful, the command will return
Note: Recovery mode cannot be initiated if the NVIDIA® Jetson Orin™ NX module is
disassembled. Ensure the NVIDIA® Jetson Orin™ NX module is installed and refer to
the image below to perform the steps:
Chapter 3 – BSP Flash Guide
"0955:7523 Nvidia
Corp"
33
Advertisement
Table of Contents
